Automated home 2.0 – #33 Our Air source heat Pump

I previously covered our MVHR system and now it’s time to look at the rest of our mechanical setup.

UPDATE – check out our running cost for the first full year

Electrification of Heating

Heating, just like transportation, will be increasingly electrified over the coming years. certainly the ‘Sixth Carbon Budget’ recently published by the climate change committee (December 2020) points to a future where there will be millions of heat pumps installed across the UK, predicting…

…a total of 5.5 million heat pumps installed in homes by 2030, of which 2.2 million are in new homes
Climate change Committee

Hitachi Yutaki heat Pump

There seemed little point in fitting another oil or gas fired boiler, in fact we chose not to burn anything anymore.

So the new Automated home is heated using this 11kW Hitachi Yutaki M Monobloc Air source heat Pump. This air to water unit supplies the Roth underfloor heating system on both floors as well as the 300 litre Joule Cyclone DHW tank.

There is plenty of FUD circulating on forums and Facebook groups about heat pumps. lots of ‘expert’ opinions from people that have never owned one or lived in a house with one. While there are unquestionably horror stories out there (as with every trade), a correctly spec’d heat pump, developed and installed by a real expert company like Daly Renewables, in a well insulated airtight house is an efficient solution.

Running Costs?

The heat pump is controlled by our Loxone smart home system which is also collecting energy usage information as we go through our first winter season (more on that in a future post).

So while we’re still gathering the data to compare the running costs with our last similar-sized house and its oil-fired boiler, for now we can say that comfort levels are a substantial improvement. The house feels so much warmer than the old place (and we’ve been down to -6° so far this winter) and the big tank is always full of hot water.

[UPDATE – here are the figures for our first years running cost]

Time to turn to Ryan Daly once much more for an explanation of heat pumps and much more on the system that keeps the Automated home warm in the winter.

Heat Pumps Explained

Air Source Heat Pumps work using similar technology as ground source heat pumps, but instead of having pipe work buried in the ground they use the outside air as its energy source.

In the UK and Ireland, the outside air temperature rarely goes below -3°C. The heat or energy moves from hot to cold (the 2nd law of thermodynamics) and the refrigerant in the heat pump boils at very low temperatures of -30°C, so the difference between the outside air and refrigerant creates the energy that flows into the pompa de caldura. An Air source heat Pump uses a fan to draw the outside air across the evaporator.

An Air source heat Pump will have an efficiency rating of roughly 350% to 470% depending on system design and installation. In easy terms, this implies that for every 1kW of electrical power that the heat pump uses to power the compressor, which is the main component in the heat pump, it will get the remaining 2.5kW to 3.7kW of energy from the air outside.

In comparison a fossil fuel gas or oil boiler will only ever be 70% to 95% efficient. The lower the heating system operating temperature the much more efficient the heat pump will be and for that reason this will result in lower running costs.

Heat Pumps are an optimal fit for new build homes which have an Underfloor Heating System installed as the water running through the UF Heating pipe work is less than 35oC. The system is developed to be left running and will maintain a constant temperature in the home and will always have the hot water tank heated ensuring ample hot water for showering and bathing. In the summer when the heating is not required the heat pump can heat hot water separately.

At Daly we recommend all our clients to work closely with their architect in purchase that they specify low U-values and come up with an air tightness brief to make the house a low energy dwelling from the outset. In our experience, our systems work really well in wood frame houses as they are well insulated and air tight but they can also carry out as well in masonry houses as long as the air tightness steps are applied correctly on site.

In terms of capital cost an air source heat pump will cost roughly £2,000 to £3,000 much more to install over a conventional oil or gas boiler system. depending on fossil fuel prices, the payback compared to an oil boiler system will be between 3 to 6 years. The main difference in an oil boiler and a heat pump is the fact that a heat pump has an inverter compressor which implies it can match the exact heat load of the house. It does this by varying the frequency of the inverter. The smallest oil boiler available is 15kW and has a high temperature heat output which is not developed for an UF Heating System.

If using UF HeatiNG cu ulei, supapele de amestecare trebuie montate la colectori care diminuează temperatura apei în sistem de la 80 ° C la 35 ° C. Acest lucru duce la ciclismul cazanului mult mai de obicei, ceea ce duce la o mai mare costuri de funcționare. Având supape de amestecare la colectoare împinge costul sistemului de încălzire UF și adaugă, de asemenea, la cerințele de întreținere pentru sistem. Acestea nu sunt necesare atunci când se utilizează o pompă de căldură pentru încălzirea încălzirii UF, deoarece pompa de căldură se poate potrivi cu temperatura exactă necesitățile de încălzire UF prin utilizarea unui proces numit compensații meteorologice.

Compensația meteorologică utilizează un senzor exterior care este pre-conectat la unitatea pompei de căldură. Acest lucru reglează automat temperatura debitului prin casă prin încălzirea UF în funcție de temperatura exterioară. Această operație inteligentă ajută la scăderea costurilor de funcționare chiar și chiar mai mult, deoarece va permite pompei de căldură să ruleze la o temperatură mai scăzută pe zile mai ușoare și să se ridice când devine mai rece afară. Făcând acest lucru, de asemenea, ajută la menținerea temperaturii interioare la un nivel confortabil pe o bază continuă.

În casele unde avem pompe de căldură instalate (revenind acum 10 ani), am constatat că încălzirea anuală comună și costul apei calde asociate cu o pompă de căldură sursă de aer va fi în regiunea de £ 350.00 – £ 700.00 pe an pentru o medie de 3000 de picioare pătrate. Acesta este costul electric pentru a acționa compresorul în pompa de căldură. În comparație cu un sistem de cazane de ulei, aceasta funcționează în mod obișnuit la între 50-70% mai puțin costisitoare, în funcție de sarcina energetică a casei și de prețurile combustibilului. Prețurile energiei electrice tind să rămână mult mai stabile decât prețurile petrolului și să știe că factura dvs. va fi mult mai mult sau mai puțin aceeași pe fiecare lună permite clienților să precizeze că toate bugetul familial esențial. Unii clienți primesc o tarif de economie 7 instalat în cazul în care obțineți energie electrică pentru mai puțin de jumătate de preț timp de 7 ore pe timp de noapte, care poate fi un mod foarte accesibil de a funcționa un sistem de pompare de căldură.

Celelalte beneficii principale pe care o are o pompă de căldură
pe un cazan de gaz sau de ulei, deoparte de costurile de funcționare mai mici, este că nu are
emisii dăunătoare, nu necesită întreținere regulată, nu necesită
Combustibilul de combustibil UPS la fiecare câteva luni, deoarece folosește puterea electrică pentru ao opera și acest lucru
De asemenea, implică proprietarul casei are doar o factură de utilitate pentru casă. Cu mai mult
Energie decât oricând proveniți din surse regenerabile, vedem pompe de căldură aici în Irlanda
și Marea Britanie ca parte și parcelă a viitoarelor opțiuni de încălzire eficientă din punct de vedere energetic.

Trebuie doar să privim spre Suedia unde
80% din toate casele de uz casnic sunt deja încălzite de pompe de căldură.

La Daly am furnizat și instalând gama Hitachi Yutaki de pompe de căldură din surse de aer pentru ultimii 7 ani. După instalarea a sute în acea perioadă am devenit cel mai important instalator de pompă de căldură din Irlanda de Nord și am construit o mare cunoaștere a produsului în acea perioadă. Unitățile au o garanție de 7 ani, care este una dintre cele mai bune garanții din industrie și am realizat cursurile de formare a produselor pentru a oferi un serviciu complet de asistență după vânzări.

Contactați pe dalyrenewables.com pentru multe informații.

Data viitoare

Într-un post viitor POST, vom analiza controlul pompei de căldură din sistemul nostru Loxone și costurile de funcționare ale încălzirii noastre. Între timp, amintiți-vă să verificați instagramul nostru pentru a urma proiectul, citiți restul mesajelor automate de origine 2.0 blog și găsiți legăturile către toate produsele pe care le-am folosit în auto-construirea noastră.

Imparte asta:
Facebook
Stare de nervozitate
Reddit
LinkedIn.
Pinterest37.
E-mail
Mai mult

Whatsapp.
Imprimare

Skype.
Tumblr.

Telegramă
Buzunar

Leave a Reply

Your email address will not be published. Required fields are marked *

Related Post